We recently had a request from a customer to do some pump alignment. Normally that would mean shaft to shaft alignment, but in this case, they wanted bore alignment. Read more
28 April 2020
How to deal with obstructions to line-of-sight
A couple of months ago, we were hired to perform an alignment on a motor/gearbox setup with a 9-foot spacer coupling in between. The obstacle this time around was that the spacer coupling was going through a square steel support beam. Read more
03 December 2019
The Dos and Don’ts of shimming
Don’t lose on the swings to make up on the roundabouts. Read more
22 October 2019
Reliable machinery installation
“Reliable machinery installation” – it sounds like an obvious thing, don’t you agree? But where does reliability actually start? Read more
